https://kolokola36.ru/content/and-who-essentially-most-honest-0
Insyde Software SCU May 20, 2003 5:40:09 Main Advanced Security Boot Exit Exit Saving Changes
————–Exit Saving Changes——————- Exit Discarding Changes Press to save lots of the current Load Setup
Default Setup parameters to CMOS RAM. Hardware Monitor This submenu allows you to monitor the parameters for essential voltages, temperatures
and fan speeds. Parameter Onboard Video Enable/Disable
on board VGA Controller Dual Monitor Video Select which graphics controller to make use of as the
first boot system. I counsel you learn the CRT Monitor forum.
2. Click on “Read” to read EDID information. See Post Code Checkpoints part of document for extra data.
Chapter four Trouble Shooting This chapter supplies bother capturing data
for AT1921/22 NO Power Check P/B CN101 pin7 12V, Separate
M/B & P/B Check CN101 Change P/B pin15V Correct? Pull the the ability
supply module towards the fitting. Tilt the power supply module slightly to the skin(1)
and elevate it out of the chassis(2). Page forty eight Power Management ACPI Mode Power Management
Mech. Deep Power Off Mode If Enabled, it is going to support
EUP Lot6 Function. Please click “FullOS” and status will show
“Change mode success” , long press “Power key” to shut off M330.